Separate names with a comma.
Any advice on where does he 3dr telemetry tx radio should be connected on the MK flight control board (or is it on the nav ctrl board)? Thanks
You're absolutely right Andy, and thanks for your input. I've been flying a Cinestar 8 with a camera gimbal for three weeks now (mostly on...
That's a great diagram, thank you very much Adam, it makes everything a lot clear and easy to wire. However I don't quite get what's coming out...
Thank you Gary, I'll try to figure that out with the MX-20 and one rotary knob. I'm not using come home at the moment, so I could use a three way...
Good afternoon. I'm thinking on building a single operator setup on a 2 axis gimbal with Radian stabilization for a Cinestar 8 frameset. The only...
Worked with that value unchecked. Thanks Gary.
Well, I have the same problem as described by Sean. Checked the cables and followed the procedure exactly as the Quadrocopter video explained, but...
ok. For tilt I have channel 2 (right hand stick un and down). For Pan channel 1 (right hand stick left and right). And for roll channel 3 (left...
Well Gary, perhaps this sound silly but I haven't been able to control the gimbal. As far as I'm concerned, I will use ANY control recommendation...
Gary: 1,2.) How do I map that control on the MX to channel 2? or any other to other channels? 3.) Thanks about that, now I know what values to input.
Sorry for the wiring. As soon as I have everything working out as it should, I'll clean up the mess.
Well guys, you're the best. So far, I've managed to successfully (or at least it seems so) installed and wired all radians to the system. I'm...
Hi guys, and thanks in advance for all your support. I'm now installing the RADIAN system for the 3 axis gimbal, but I can't seem to find a proper...
I've tested them with a voltage value of 12V DC. Still on. The servo wire is connected as indicated with the yellow cable to the corner. Also,...
Ok, now all components on the Ext PCB are soldered which are 2 indicator LEDs (orange) with their respective resistances, one 9V regulator with...
I need help on the telemetry reading on the MX20. All parameters are always on 0. I will appreciate any advise on this issue.
Thank you Gary. I'll sort this out.
Thank you Gary.
Thank you Gary... The LED wiring is soldered to external PCB on S1 and -, but there is something that I should tell: there was one circuit not...
Thank ou Andy... The LED wiring is as you described it on the tutorial. It is soldered to external PCB on S1 and -, but there is something that...