/dist/images/branding/favicon
Separate names with a comma.
Hi Guys, Following my posts about voltage reg. Can I swap my 6v/5a lipo regulator for a 5v/5a ubec? It's to power the gimbal servos and radians....
Thanks Guys, What about the Radians? Can i simply swap my 6V regulator that feeds the gimbal for a 5V? Tony
Hi Andy, Yeh, I opened the original and have seen the board. Looks like the chip that has burnt out? Wonder if there's a replacement for that!...
Hi Gary, Yeh, I've seen this issue being discussed. Checked with a volt meter and i'm reading 6.04?!
Hi Guys, I am running the 2 axis gimbal on my CS6. Only actually used the gimbal twice and both times the roll servo has smoked itself! Both times...
Thanks Gary, That makes sense and now i've heard it from yourself i'm ready to give it a try. Weather here in NW England is rubbish today! I'll...
Hi Guys, I'm keen to try MK GPS modes and feel confident about how to use them. However, i'm not confident about how to exit a GPS mode/s? Stick...
I think this was something to do with the compass. I re-calibrated it and since then it's been fine! Tony
CS6, MK flightcontrol V2.1 & GPS. Freefly 2 axis gimbal, Graupner MX20, Canon 5D MKII, Fuji S3pro, BMD Pocket Cinema Camera on order!
Andy, Thanks once again for your advice. Unfortunately, i'm working away a lot at the moment so time on the project is limited. For a few weeks...
Hi Josh, The CS6 was built by a company here in England. However, when i took ownership of it, the software was out of date and i made the...
Thanks for this William. I know what i'll be doing tomorrow!
Agreed, the frame rate does give an unusual look to a spinning rotor!! I'll try and get some decent audio at least. Tony
I'm with you Andy. Will give it a go
Will do. I got a friend to try and film it on his phone but it didn't really come out that well!! I'll have a proper go at it at the weekend.
I'm up in the air and yes, dead chuffed. Feels great and slowly working my way towards more complicated manoeuvres (by my standards). Seem to have...
Thanks William, I think it's 2) or 3). I should do an accurate acc calibration perhaps? Then check the trim isn't a compounding issue!? Any...
Hi Guys, I'm still a newcomer to the multicopter world so bear with! I've completed 8 flights so far just doing the basics and so far so good....
I hear what you're saying and i'm not offended! I have a 4 channel heli that I have been flying for around 12 months. Wouldn't say i'm an expert...
Thanks Andy, I'll give them a go. Even if they don't, I can get them converted. Also...... The MK USB arrived today and my C6 seems happy again....