/dist/images/branding/favicon
Separate names with a comma.
They've done give aways during NAB... I'd wait to see what's coming out. I got burned right before the M10 launch with a Cinestar 8/radian gimbal...
Copy is a strong word, especially when dji was the first to market with direct drive brushless gimbals for multirotors. The freefly products...
The performance is currently unknown since they aren't out in the wild yet. It'll be interesting to see how they perform when stacked against the...
Got the firmware updated, and it seems to have corrected the spinning freely issue. I only had time to do a quick test on it. Thanks for the...
Thanks Loren. I sent an email to support for firmware update instructions.
I've had issues with the motor not having enough torque during manual calibration, as well as the motor spinning wildly after calibration. I...
Voltage is a big factor. Motors are measured in KV, which translates to revolutions per volt. If you drop the voltage your motors will spin more...
It's pretty simple. Once you remove the screw in the cam lever, you can slightly spread the ring by hand to remove it. You then get full access to...
Another option you have is to switch to a long range UHF transmitter and receiver. I have been waiting to hear if the lightbridge is worth it....
Something seems off about those numbers. What's your actual AUW? 9406 grams seems really heavy for a gopro setup...
Looks like Quadrocopter has a cinestar style gimbal to DJI mount. Just another option http://www.quadrocopter.com/Gimbal-Adapter-Plate_p_1102.html
Mine worked well, but now I'm running direct drive GB85 motors. I only ran into issues with cogging on the pan with a 5208 motor, but I swapped...
You need to adjust the camera tilt balance to raise the center of gravity inline with the tilt motor. [media]
I find it strange that the video mentions nothing about it being a hobby rc jet., and shows a clip of a multi rotor instead.
I'd think if there was a solution for retracts on the cinestar, then it would work well for easy transitions. I don't mind sorting out cg on the...
I don't see any options for more toads in the store. Do you have to order 2 to full sets to be able to swap from a handle to something else?
You can program a mix on the dx6i to create a 3 position function on the gear channel. The programming can be a bit tricky, but you can tailor it...
I haven't run into any heat issue with 4s. There are some heat sinks available that are self adhesive and perfect size for the alexmos motor...
DJ over at photoshipone has some of those on hand and is currently testing them with the alexmos controller. They're very larger motors, and quite...
So you're the old man that is blind, but sees everything? Up until a few days ago you didn't know that the pan axis had to be balanced on...