/dist/images/branding/favicon

Search Results

Search Again
  1. Tristan Hallereau
    Post

    Converting my CS gimbal to a brushless gimbal

    Hello everyone, I made my handle gimbal 3 axi few weeks ago. My current setup: - 2 Alexmos Controller V1.0 Firmware: 2.30 b5 (One for the...
    Post by: Tristan Hallereau, Dec 3, 2013 in forum: Camera Mount Misc
  2. Tristan Hallereau
    Post

    Converting my CS gimbal to a brushless gimbal

    Hello, I made a Steady Hand Gimbal with 2 alexmos controller. One for the tilt and roll with the IMU behind the Canon 5D the other one for the...
    Post by: Tristan Hallereau, Aug 26, 2013 in forum: Camera Mount Misc
  3. Tristan Hallereau
    Post

    Converting my CS gimbal to a brushless gimbal

    Hello! I am trying to build a 3 axis brushless gimbal. I have already a 2 axis AlexMos controller. I saw the option for Yaw axis will be...
    Post by: Tristan Hallereau, Jun 24, 2013 in forum: Camera Mount Misc
  4. Tristan Hallereau
    Post

    Converting my CS gimbal to a brushless gimbal

    Hi Bill, I checked your photos with the 5206 GBM on the tilt side but I don't see where is the motor's shaft. On the 5206's datasheets, there...
    Post by: Tristan Hallereau, May 2, 2013 in forum: Camera Mount Misc
  5. Tristan Hallereau
    Post

    Converting my CS gimbal to a brushless gimbal

    Thanks Bill for your answer. In fact I'll use the gimbal with my hands (like the Mövi M10) so I don't have a problem with the props!
    Post by: Tristan Hallereau, Apr 28, 2013 in forum: Camera Mount Misc
  6. Tristan Hallereau
    Post

    Converting my CS gimbal to a brushless gimbal

    Hi Bill I'm Tristan, new here. I just read all the pages and then all the work you have done. Nice job! For one month, I'm looking on the web...
    Post by: Tristan Hallereau, Apr 27, 2013 in forum: Camera Mount Misc
Showing results 1 to 6 of 6
Search Again