/dist/images/branding/favicon
Separate names with a comma.
Andy, Gary - thank You for Your care. I really will never start the motors with props attached indoors. Because , as You can see , the off-on...
Yes, Andy, everything was just vise versa Thanks again, specially for safety issues. In case I need to start motors with props indoor I will wear...
Andy: THANK YOU for Your Warning! I will take into account Your advise. Now. I was sure ( I do not know why) that Number 1 motor (RED Boom) should...
Hi, Just finished my assembly of CS 8 HL. Today switch it on and ....... what the hell it could be? When I test motors with MKtools everything...
Andy, No, the Flight Controller is mounted exactly as it should be ,with arrow looking directly to the boom N1. For FC board, fortunately there...
Here are some photos with the project "Cinestar8 with retractable landing gear" David
Thanks Dave, I will correct them immediately. David
Thanks, Gary , for Your response. I definitely will buy real FF hub plates , if You suppose, that deviation on the PD board may be an issue....
So, measurements done. Here is the deviation from the vertical direction 1 ------- -0.3° 2 ------- +0.5° 3 ------- +1.2° 4 ------- +0.2° 5...
Janne, thank You very much , I will try this app today. Hope it will help. By the way, when we say, 0° alignment , what deviation could be...
I made that propeller "disc" check today. Not at the fly, but on the table at home. Seems they are all in line with each other. At least with my...
Thank You very much, Andy. I definitely will check out this document, sure it will be very useful. Could You, or anybody else here, give me an...
Hi, It is absolutely clear , that at some point most of us face with a problem of appropriate motor selection for our setup. I know, that there is...
Hello to All, So everything works just fine at home. Waiting for normal weather to test the landing gear outside. David
Yes, Andy, I am going to attach this retractable landing gear to my Cinestar 8. I already test the servos with the servo consistency master (see...
Sure I am using MKTtool, and this CTRL9 in MKtool's Channels window shows me P5[Ch9]. It is 3 position switch, but I suppose that I can use it...
Thank You, Andy. I will try to do everything according Your instructions. I bought this set from here. It has , as I said, just one little paper...
Thank You Andy for Your instant reply, as always :) Unfortunately no documentation for this item, just some diagrams for assembling. So, the...
Hi, Just finished to assemble retractable landing gear for my cinestar 8. But no idea where to connect this white wire to receiver (or may be to...
Thank You Andy for Your comments. Tomorrow, if no rain, I will test this changes. Remarks about the emergency parameters are definitely very...