/dist/images/branding/favicon
Separate names with a comma.
New Firmware?
Hey I have a problem with 2 of my modules (Tilt / Pan) Tilt: Can suddenly no longer operate so high down (2x mode on / off again Okey) Pan: This...
Release date? I need it ;)
My configuration: Octocopter with GR-24 3-axis gimbal with GR-24 Transmitter MC-20 Philipp
Hello Is it possible that only 8 channels can be used? I have a GR24 but there are only 8 channels displayed (SUMO-12), channel 9-16 are the...
Hy Philip The problems are receiving loss [IMG]
Hy Anyone have a solution for the problem mx-20 hott / mx-12 hott. I already have problems after 50 meters. Someone of this configuration is...
Thank You Andy, sorry for my English :) If I turn off the transmitter MX-12, the modules switch on STABILIZED SLEW. See in the picture. When I...
Hi Andy I have now tested 3 modules individually ... Each Radian is activated as soon as I put +5 V. Only Servo(Port4) and +5 V(Port1). Each...
Hi Andy I have now switched OFF the File Safe on each channel. The same problem When I use the Radian without receiver, attached directly to...
Hey When i Tunr OFF my Graupner MX-12 with GR-16 (FailSafe) Turns the Radion ON. FailSafe settings I've actually done. Connected via PPM. Someone...
I have tried several times until I had it.
Hi wolfgang I have also connected the CamRemote-2a and the NEX5, works great. You have the right switch trim in my MX-12 I have 88% and 88%. Here...
Hello Tabb These steps have been performed several times, unfortunately without success. With the other two Modules, it works without...
Hello Andy Thank you for your Help :) I hope Tabb or JoneC can help me, with this Problem First, the problem with the FreeFlyUSB and now...
Hello Andy When i connect to the Power it's the Radian on the table. I have two Modules without Problems on any position (Pan, Tilt, Roll),...
I have a problem with a module. 2 modules which are OK behave like in this video [media] 1 module that is broken is like in this video [media]...
I have a Problem I can not plug in the USB connector, at the corners, it still has tin. or I have a wrong usb connector (microUSB)? Thx [IMG]
Works the Radian-System with Futaba BLS451 Servos? Thanks Philipp