/dist/images/branding/favicon
Separate names with a comma.
The following is a link to a segment from last night's NBC's "Nightly News":...
Thank you Andy! I'll keep at it!
Alright. Bearings came in. Installed them. Now I have new bearings on motors 1, 3, 8. Also new props all around (the APC SF ones). Did a test...
Yup, that's what I'll do, hopefully over the weekend, if my bearings show up by then.
No noise either. Not even a simple click. That's what makes it so annoying. LOL
No smell either. Nothing out of the ordinary other than the small vertical play that Andy is talking about.
Mike - I did not feel the vibration, no. The magnets inside the bell didn't seem to move when I cleaned them. Didn't get a chance yet to do a test...
Thank you Andy. I'm afraid however I don't really understand what I should do next... Do I keep using the motor despite the sound, is there a fix,...
Alright, just pulled the motor apart again. Bearings seem nice and tight. I gave the inside of the bell a nice clean with a toothbrush. Once I've...
Jason - Thank you for your suggestion. I'll check on that. I used Bart's tool to change the bearings (never had trouble before).
Andy - checked for vertical play. Outer bell moves up and down less than 1mm, but that is more than any of the other 7 motors. Do you think that's...
Hey guys - One of my motors stated making a very strange noise. I changed the bearings on it, but it still does it. Please see the attached...
Hi Jose - Is the battery plate above the white disc? What kind of adjustments did you need to make to get the fan attached to the battery plate?...
http://gizmodo.com/take-a-stunning-drones-eye-tour-of-burning-man-1278862158
Brad and Andy, thank you for the explanations. I'll get some more heatsinks and add them to this board as well. My PDB is already raised up a bit...
OK Andy, I really need to get a ruling on the heatsinks. I had them on the old board, but when I got a new PDB and new BLs, I didn't install new...
I should make a mention that I was also flying in direct sunlight and in about 85 degree (and rising) outdoor temperature. As opposed to the GPX...
Steve, thank you for taking another look at the GPX file. The AUW is an approximate 13lbs (I don't have a fishing scale on hand, so I had to use a...
Alright. Grabbed some lead tape from a sporting good store, and got all the APC propellers nicely balanced. Did a couple flights, but I'm not...
Alright. Finally got all my parts and tools and replaced the bearings this morning before going into work. That was quite easy with the little...