/dist/images/branding/favicon
Separate names with a comma.
Here is my cs8, from Spain.... Cinestar cs8 Axt-141 motors (kw4) Ice 50 Xoar 14x4 Wookong m Power dist. board 8 + dual bec Futaba s-bus 6s-5000...
@Bill, my condolence to you too!... Guys, any advice over this gimbal settings?. Now i´m carrying a canon 550d, because my hdmi to av conversor...
I've watch all related but no solution. Tomorrow i will carry the canon 550d ( i dont like) . Thanks Duane Jordi.
I reflashed the original firmware again, thinking that was a software problem, but the same result...
Steve you were right, the new one (v2) has no i2c errors and seems to work fine. Tomorrow i will try. Thanks. jordi
Sudenly the gh2 hdmi video has gone out. I've try 3 diferent hdmi conversors and 3 diferent hdmi cable, but only i can see video when i put in...
Thanks steve, tomorrow i'll buy new one...i will share results. Thanks again. Jordi
The cable is 20cm long, and with or without imu solded its has the same problem....
Thanks Andy.
Actually i have the board out the gimbal, and the error is the same that mounted. Here a picture the green light is flashing. Thanks.
Yes with 0 values the same error. More and more i think the board has an error.
Is a 3 axis guimbal but only 2 brushless pan and tilt. Yaw just a hitorque servo. Propellers and motors balanced Always full i2c errors from 0 to...
I cant take good shoots with my cs8. The picture always shake , at first i thought that the problem was the o-rings. I've tried all the...
I'd the same problem and finally drilled the horizontal boom ( under the camera to acces to the camera screw )and put some weight on the back side...
Thank you Kari, tomorrow a friend with a cnc will cut my desing in carbon fiber for the pan motor support.i will try at first with this, meanwile...
Finally i decided to belt my pan motor, i don't know the best gear relation, just i have found this gears, 130 and 26 tooths. The relation is 1...
Sorry for my ignorance, what is SDI/IP? Thanks.
Bill, where did you buy the metallic pinions of the brushless reduction?
hi jose luis, is an alexmoss?. I had the same problem and an advanced calibration solved this.
I guys, i folow you since the beginning. I´ve a cinestar CS8 with casttle 50 amp kw8 motors and xoar 14x4 (dji wookong m). The gimbal is a clone...