/dist/images/branding/favicon
Separate names with a comma.
Where (either on the website or elsewhere) can I order some replacement and backup cables for the Spektrum receiver and the Movi Controller RX? I...
When the m15 is connected to mimic and is in any setting other than direct the roll is off by about 2 degrees in that it actually goes away from...
Also, I've mounted the battery bracket (for camera and AKS) on the top bar and run a flexible 10 amp rated silicone cord down the frame and onto...
Just wanna second changing batteries every time the 3 light indicator drops to 2 lights. It's my experience that things go wonky when there's...
Got one of the ones from brushless. They are very good. Much thinner and more flexible than the custom 24 inch we had before.
Yeah, it's way more than not walking smoothly. It's rolling back and forth for some reason. Tilt stiffness should be a bit higher, and roll and...
We've got both the 1630 and the Cinema Oxide (which is very nice as well) but I use the 1630 mostly since it holds a totally rigged Epic and most...
Also have the 1630 setup to hold a totally rigged and ready Epic with any lens, FF, Paralinx etc. Great for fast setups. It's got to have every...
I talked with a rental place that said their RT motion system was driving other motors, or maybe they were referring to the future. They said it...
Mount on back won't fit. Other option is to put power on the top bar then route a custom cable down the frame following the sensor cable. I ran...
Great piece. I've found the easyrig to really help in the heli, although in an A-Star the key seemed to be to flip up the seats, and sit right on...
I've noticed the exact same problem on both cars and helicopters. Horizon drifts every time even though the tablet says GPS locked
f2.8
I've used the 24-70. It works well. I balanced at about 50mm, and that let me move from 35-70 without any issues. I didn't try at below 35....
Very stoked on boat mode when it comes. Will be very useful.
Here's a dropbox link. The bumps and poor framing are from when I am pushing and wiggling the unit to try to level out....
Easyrig worked well for skiing. Shooting sideways was no problem with a second op in control of the cam. Main problem was paralinx cut out as...
Easyrig 3, 9" extension, 300n shock. I'll upload the footage tonight if i get the chance. If not tonight, tomorrow. Thanks, Tabb.
I've been shooting a bunch with the unit, lately. Setup is with Epic - no sidehandle, powered by AB mounted on top handle. Bartech/Heden FF, and...
We've got an Easyrig 3 with a 300N 9" extension arm. It works really well as long as you're moving smoothly. It's impossible to completely...