/dist/images/branding/favicon
Separate names with a comma.
Hey Joshua, This might seem obvious, but it's an easy mistake to make. Confirm that you're MoVI is set up to be controlled via the Movi...
Yep. I just got an extra channel after binding with an AR8000. While I know the radio would need all 9 channels, I didn't think that the satellite...
2 x DSMX satellites. Used an AR7010 to bind them one at a time. Could that be why I'm short 2 channels? When ALTA is powered both sats are solid...
Yes to both. I swapped the channel inputs and mapped RLv to climb rate and RKnb to Velocity. Climb rate still works with a different input (RLv)...
Hey everyone, I'm looking for help mapping the velocity clamp and arm enable channels. All other channels mapped and working. DX9 port...
Delivery services??? Over all the other potential uses and with all the potential issues of delivery by UAV. Money does talk in our government.
Great stuff. Where were you flying from most of the time?
There's a lot to be said on this topic and the competition. But in short, the MOVI outperforms all competition in camera stabilization, ease of...
Check to make sure the IMU cable didn't get jiggled out. Check under the camera tray/mount on the tilt bar. Do you have a tablet or comp. so you...
But a HL setup with no payload? Or did you have a test payload installed? Do the MK electronics heat up that bad? Never used them. Could be as...
They did indeed have the camera on display. They provided no info and didn't even field questions. And I didn't see any mention of 4k on that...
Gary, I'm currently of the opinion that even 50F can have a major impact on the batteries ability to supply enough voltage. There is also lots of...
What kind of temperatures have you been flying in? Have the batteries been stored inside at room temp?
Hey Jason, I ripped a USB port out and sent it back to flyduino in Deutschland. They fixed it right up. They weren't sure if they could fix it...
Thanks for sharing Gary. I've always carried them on but it would be easy to forget one on a gimbal or somewhere in a peli.
Is anyone actually using the external flight control gain inputs with AlexMOS firmware on a 3 axis gimbal? And can anyone comment how follow...
What do you need either of those specs for?
Hey Lauri, it's unlikely that your issue is pole count but I thought I might point it out. The auto calibration is rarely correct anyways. For...
I've been told you count magnet poles and not the stator. And those figures would be consistent with what the manufacturer lists for their pole...
Hey Lauri, I think those are 22 pole motors not 24. I believe it is incorrect on the brushlessgimbals website....