/dist/images/branding/favicon
Separate names with a comma.
I am selling this amazing CS8 this is a real cinestar 8 I paid thousands for frame and in MK (mikrokopter) electronics, and motors on this copter....
HELLO EVERYONE. Its been a long time since the last time i wrote a post. I have a problem. I bought all the parts for my cs8 and 3 axis gimbal....
Thank you , yes my wound is doing ok it just hurts when I walk, also when the accident happen my father in law was here and he is a doctor so I...
Hello everyone, I had my first accident and I havent even been able to actually test or fly my cs8 at all. I was about to do a final test...
Hi everyone, I already tried all the rocmmendations, I went in to mk tool and check for the "Dont start with out.." I only checked "ignore...
Thank you but what do you mean by reversing the plug ? I mean I already took out the potentiometer and I level it but when it rolls to the side...
Andy, I tought I could after watching several tutorials from quadrocopter, I followed this turorials and they are conected to the AR8000 and thats...
Hi Gary , I am not using radians at the moment they are out of my budget, maybe when I do a couple of flights I will be able to get those :) I...
First of all than you for your help. What I meant is I power up everything then I roll with my dx8 to the right and the servo does it but it...
I cant turn the motors ON. :(. I know my receiver its working, I see the signal perfectly on the MK tool but I push the THR (gas) and the motors...
Hello I am a newbie learning fast and I have a problem and I am looking for help. Here is my issue, I did as far as I know a fairly good...
I want to thank Jason Smoker and Andy. I got it finally without errors now I just need to find a good tut on how to program the DX8
Oh men!!!!!!!!!! after looking at the wiki and comparing it to the picture I took to ask on the forum I realize that I soldered in a totally...
Yes super thanks for the help, I conected the MKUSB directly to the NAV and I was able to update, now on MKTool Nav control appears green but my...
I am conecting the MKUSB to the FC and then the FC to the NAvi board I am at my full time job I get out at 7 am when I am out here I would go an...
Thank you for your fast response but I already did that without the jumper and it didnt work. But what setting I have to save if this is my first...
Hello again evryone and again I cant express enough how much I apreciate the help I have been getting. Well I bought new parts and used parts...
Thank you This is what I did , pics . I followed the wiki instructions, but I am not sure if thats it, I already bind them, but thats it ?...
Hello everyone, I am very very new to the forum, I have been here for months just reading a learning but there are a ton of things that I still...
Hello Andy how are you ? I bought the two DVD's the how to build the C8 and the MKTOOL. I have one question.. I am following the DVD to the letter...