Separate names with a comma.
Hi I am still using a Radian 2 axes on my Cinestar 6, and i am wondering when to change the Cinestar dampeners ? I usually fly with a light cam...
Thanks Ryan Strangly they don't sell the 4012 here, they have the 4014 instead ...
Thanks 340,400,or 480kv ?
Ryan, Thanks So you have the hexa with tmotors 4012 running with 15' props, MK BLv2 and dual 10000mah 4S lipos , plus a movi m5, and the A7...?...
I see you are using MK BL V3 with Tmotors 4012, why not MK 3644 motors ? Nobody seems to uses MK motors, specially done for this new BL V3,...
Hi, I guess you speak about Mikkrokopter FC's If you go higher than ≈ 3000m you will need the 2.5 FC ! (check on the wiki the exact limit.) With...
Thanks Gary
Hi, What is the weight of the M5 in a multi rotor configuration ? I am surprised that the handheld config seems to be heavier than the M10 (≈ 2,5...
Hello Michael, I am sorry not to be able to help a lot ... My project was cancelled before I finished the research ... When i stopped searching I...
Hi Andy, thanks I did the same research and found the same stuff EASA in not relevant since my drone is under 150 kg ....(each country keeps...
Hello, I may have to fly my copter in Spain and I could not find precise information about regulation there. What i learned is that there is a...
The rules are the same for everybody. Basically you first have to pass a theorical exam that show you know the rules, then you have to fill a lot...
Above 3150 meters with a fc2 .1 the motors won't start if you do not desactivate the altitude sensor, i experienced it at about 3700m !...
We did the mission with 2 Mikrokopter, Cinestar 6 and OktoXL. Actually with Mikrokopter and FC 2.1 i had to desactivate the altitude control over...
Hi Nick, i guess it is too late, but, just in case if you need, i have " the right papers " to work in France. ;-) Regards Denis
You are right, it is ok with 15', i didn't check ... So it looks promising, hovering at 50% with 7kg ... What Escs are you using ?
I checked that yesterday in icalc, it is ok with 15' props in 5s, but much better with 6s. You have 15' props on the hexa ? Standard booms ? My...
To hover around 60-70% that is a little high to be confortable no ?
Hi thanks for the reply That is great fly time, (i don't have that at all actually, 8-9mn) i imagine that you are confortable with the power...
Hi All, I have a Cinestar 6, MK electronics, with a 2 axes Cinestar Gimbal and usually using a CX730, i use mostly Xoar 14'x5 with MK 3638 motors,...