/dist/images/branding/favicon
Separate names with a comma.
Andy - this is a brand new Flight Control V2.1 ME with ACC Upgrade board from Quadrocopter. I'm am in the process of finishing the build....
I gave the re-flow attempt a try - no luck. :(
Thanks Andy. The pressure sensor and it's legs look fine. Guess I'll contact Quadrocopter and see what they say.
Building my first CS8. The only problem is that the FC gives a Pressure Sensor Error. Any suggestions or do I just contact Quadrocopter and...
Sounds good. That's what I was thinking!
Thanks Andy. I'm still not sure how this impacts me since i'm using the Spektrum satellite. I take care of telemetry via the TM1000 and a wire...
Quick question. Started building a CS8. I soldered the spectrum satellite as per the mikrokopter website - same as I did when I setup my CS6 over...
Great news. I have been flying almost every day and the GPS hold has been working perfectly at 85% gain. Had one day with moderate winds up to 15...
Excellent information Dave and Andy. Yes, the compass was calibrated prior to the flight so that was probably not the culprit. I will reduce...
Thanks for the quick reply Gary. I'm carrying only a 6,200 mAh battery and CX760 so the weight is nothing extreme. I have yet to actually weight...
GPS hold has worked very well for me. The position fix stays dead on, even during windy conditions. However, sometimes the ship will begin to...
Thanks Tim and Gary. Great info!
I have been flying the freefly CS6 for almost two full seasons now. With the Radian's on the 2-axis gimbal matched with the Sony CX760, capturing...
Very true Gary. I have noticed the parking method for photos is going to generate heat. Wish every work/flying day was 60 degrees outside....
Thanks Gary! I did not remember going into return home mode so that makes sense that it did not occur. The dramatic pitch that happened when it...
Here are the GPX files for the flights before and after the one above for reference. These two flights were 6200 mah batteries so you'll see the...
I was shooting some stills of a house under construction and had my first little scare. I was flying in mostly GPS hold as I was 100-200 feet...
Works great Sean! All seems good powering off the fatshark Tx and grounding both black wires into the one on the fatshark Tx.
If I power the HDMI converter with the 5V OUT of the Fatshark 5.8G transmitter, should I connect BOTH black ground wires coming out of the HDMI...
That is very helpful information Steve! I have noticed that youtube does a better job with playback, particularly with the content I have been...