Separate names with a comma.
What lens motors are compatible with the Movi Pro ? Cinegears ?
Using this method. My batteries last more than 200 cycles and still show limited signs of wear and tear. If your using gens ace --- note they are...
Flying X8 Amp draw is yet to be determined due to broken sensor but e calc is saying about 95 -100amp in hover - I think 18 inch will do the...
Waiting on some larger props to arrive in - We tested 18 inch Foxtech blades only because Tmotors were out of stock - Foxtech's didn't really work...
I am also experiencing poor flight times and looking for suggestions. I'm running a 2 x 10,000 MAH = 20,000 setup with 16 x 5 blades for our...
Has anybody tried anything larger than 18 inch props with the KDE 5215 435s?
Thank you! Very helpful
I'm going to try splitting the satellite receiver cable to go into both the M10 and a spektrum Servo receiver.Hopefully this will give me the...
I've used / owned most all the zenmuse series gimbals, the alexmos 8 bit and 32 bit boards and a Movi M10 and M5. All have to be corrected for...
Using the M10 in handheld and on a multi rotor. I've made a remote trigger cable so I can trigger my record on/off on the red camera. This would...
Update: upon closer inspection, the satellite receiver had one frayed antenna wire. Nothing major but enough to decrease the range. System...
Thanks for the opinions. I'll move the spektrum receiver again and put a ferrite ring on the long cable. I did manage to get one flight in today...
Thanks Gary for the quick reply. Battery is brand new. I'll try re-binding the dx7 And I turned motion mode off for a couple flights. Camera is...
One more note to add it seems like it's going back to majestic mode momentarily
Hello, Currently on a job and experiencing an unwanted twitch on the tilt. Using motion mode on the latest firmware. Occasional twitch on tilt...
Have you made any further progress with finding a solution to this problem?
Hello Andy, Thanks for the detailed response. I had some good luck with settings in the 30 - 50 range on all axis. I tuned it while the machine...
Hi Brad, Thanks for your guidance, I will use airborne mode and set the smooth lock. Much appreciated !
Hello, Where can you adjust the settings for the smoothing in single operator mode on the Movi MR? I find that the unit is too reactive and...
Hello, I'm looking for suggestions on 5d3 24-105 Gain settings for the Movi MR. Regards, Justin