/dist/images/branding/favicon
Separate names with a comma.
I picked up two cases and 6 6s 10,000 packs from Michael. This deal was too good to pass up. The case is very high quality and sized about right...
I'll definitely take a look at that beacon. Seems like a cheap alternative for my smaller rigs. I originally had the naza w/gps on my big...
Thanks Andy, I researched the walston system a while ago. Also saw a lot of GPS transmitters, but required a ham license to purchase. All these...
I had a fly-away a few weeks ago. Been pretty bumbed out about it and have been avoiding everything RC related since the fly away. I'm finally...
I'd be interested too. I have a pan servo that died, Mine would come on without any control or just power on at full speed. I suspect the board...
I know you said you powered up on the ground, but this was my experience. I had the rig hung on a rope while tuning. I powered on without having...
I've been testing my units with a go pro, and I originally had my Tilt gain set to 100% and roll gain at 80% I was still getting wobbles on the...
I'm currently running 3s into a "Sport BEC" from dimension Engineering. It's only capable of 3A, but so far, it's operating fine at 6v. I'll need...
Heh. Sorry... User error again. I didn't enable DSM2-1024. It caused all sorts of weird issues using 2048. Didn't realize the DX7 used 1024.
I'm trying to map the various channels to the switches and sticks. But the channel input monitor isn't showing stick movements for the right stick...
Nevermind. I figured it out. I just binded it to an existing receiver first, then just plugged the Sat into the Radian.
This is the first time I've used a Spectrum Satellite by itself. How do I put the satellite into bind mode with the Radian? I didn't see it in the...
I just noticed on quadrocopter's site, that they will be shipping the radians on 9/15. Can't wait to get mine. :D
Thanks Tabb, Yeah, sounds like the servo might be dead. I've disconnected/reconnected the resistor numerous times without luck. I'll take it...
Hi, My pan axis servo developed a problem. This is on a new 3axis CS gimbal, that has had only 2 flights, the pan servo wasn't even hooked up. I...