Separate names with a comma.
https://www.facebook.com/cbcnews/videos/10153729011224604/?fref=nf
Hello everyone , I am returning to my CS6 settings and I'm in doubt about landing speed for failsafe, the default setting is 12, this is 1.2 m per...
Jason, works for me, should also for you, but I need that this test work in earth without touch the CS6, but this test is only to see that the...
Jason, check my post #24
Hi Andy, same thing happens, shut down motors when I turn off the radio. Gustavo.
When I shut down the radio the channel one values go to center, not 0, and I have red light in FC and NC
No, the throttle channel not going to zero, it stays in the middle 127, but the motors shut down when I turn off the radio.
Dave, but still I have the same problem, the motors shut down when I turn off the radio. What do you think it is ? Gustavo.
Thanks Dave
Hello, for those who already use the last firm, they can suggest any changes if necessary ?, these are my parameters:...
It was the firm, I upgrade to the last and dx8 failsafe works, the channel 1 going to center when I turn off the radio.
Hi Andy, I have always updated this way Gustavo. [media]
Hi Andy, each firmware has some different parameters for the improvements, it has not be a problem if I replace these parameters with an old...
I do according to manual: 1. Insert the bind plug and power on the receiver. 2. When the receiver LEDs blink indicating bind mode, remove...
Confirmed, channel 1 is not going to the center, it does not move, throtle in stick left
When I turn off the radio the channel 1 in mktools does not move. In the copter, red light in FC and NC, motors shut down
OK, done, but is the same , I turn off the radio and immediately the motors shut down
Dave, with the stick in the center position I can not bind the dx8
The truth is I do not want to use the auto-landing, I just want to set the failsafe and my cs6 can land only in case of signal loss that can not...
I use mikrokopter, it is the same ?