Separate names with a comma.
IMHO without a doubt Pixhawk cube is the way to go.
I do not have either, but in Q ground control or Mission Planner you should be able to change the arming from stick command to a switch. Then on...
All of my pixhawk controlled machines use dual switch arming. This is more a radio thing but I have it programmed to require 2 switches for...
Many taranis rx have sbus out so yes it will work with the MoVI.
Most of the 5.8ghz radios also require a license if operated at higher than 25mw. and yes I did mean 400mw.
I fly with a 1.3 ghz 400 watt vtx on the bird and fly with these antennas vas-bluebeam-pro-1.3ghz-antenna If you fly in an urban area with lots of...
Alta fpv cables are wired for ImmersionRC vtx which is different that the Black Mamba so it is not a Freefly QC problem. As someone who has been...
Finally a solution frx-pro
Graham I remember you mentioning other receivers in a past thread so I did unplug the Movi controller rx but that was not the problem....
I am experiencing the same issue as the op. Has anyone found a fix for this?
Hey Freefly how about this pDDL900-2.php as an alternative to the xbee?
Is this what you are using pDDL900-2.php ? I would buy one from you but I'm afraid if there is a risk of damage to the MoVI controller it would...
Are you using the 900mhz XBEE radio? Is it basically plug and play?
It really is too bad that Freefly hasn't explored this issue more. If you've ever opened up the MoVI controller you'll realize that the rf...
removing those two isolators should do the trick
I think you would want more than 3 amps for the MoVI.
NO or at least no way that would be worth the trouble
Steve I would try going into the menu of the futaba and try increasing the throw percentage for that channel and see if that will activate it in...
Adam the full size Connex has a fan that is fairly loud but the Connex mini has no fan (that's on the transmitter side for both).
Nice work Tim!! Definitely sucks you into the Vortex.