Separate names with a comma.
This is such a breeze, after a long shoot day to come back and run all your QCs back to storage charge.
Some lipos will come back from the field with a high cell gap. Sometimes .030, one was .050 (QC8000s).
As for my QC1200s, one of them is at a...
This keeps happening to me when I go out with clients...
I'm using a Lawmate 1.2Ghz powered by a QC1200. The Lawmate is receiving a video feed...
Day one Paracharging
I'm taking a few precautions. I wanted to light up 6 QC1200s at 20 amps on a paraboard, but for starters, lets just go at 5...
Im afraid to charge them to 100%, given the storage charge being off by 15 or 20%
Even the QC1200s I'm not sure if I should paracharge
Speaking of fires.
Andy have you paracharged your 10,000s yet?
Remember Andy, paracharging & the percentage being off by 15-20% Think that might be the "output capacity"?
EDIT: Confirmed the temp sensor does...
I just updated as well.
It's got a shine but it's flat compared to the chrome on the BL pads.
Did your main leads look like mine before they melt?
Unrelated, but my PDB is conformal coated.
Riley at QC soldered my PDB, but looking at the main leads, does it look like a cold joint compared to the BLs?
The light & hairline crack is a great idea Andy
I'll try it with a fully charged lipo and heat gun the sensor on storage charge mode. Perhaps the percentage plays a variable in it (though it...
Andy, my results are the same.
I used a heat gun, baked the sensor. No shut off.
BUT: on charge mode it worked perfectly :)
Side Note: I (finally...) got my HobbyKing shipment in.
These battery savers are a joy compared to the Mikrokopter ones. They only take a...
Thanks Bill for this! Going to purchase these asap!