Separate names with a comma.
Hi Bill, i have to say.. nice work!
I figured out that you replaced the Pan Motor with something of different..
tried the 5206 and it doesn't...
Really really interesting Bill.. nice job!
Again, thank you so much for your help. Already did and all work fine now.
Oh ty, i was writing at the same time... Thank you so much for the kind support.
ok i found it the solution.. i was using the Servos with Radian and Potentiometers..
i just tried the resistors instead of the Poti and now i get...
i attach a couple of pictures to see directly.
I'm not using the resistors connected to all the 3 serovs but the pan. I have the 2 other...
I tried a couple of times but same situation.
It reset to Roll then you need to set again the parameters but without a solution.
i tried to take a look at the servo drive bar when the current goes through the demanded angle, but the bar just continue to stay in...
Hello John and ty for the replay.
I checked the Radian Tilt Configuration and seem to be all right, i followed the Orientation Setting thread...
Hello guys i'm Brombo, nice to meet lot of good people!
I have a problem setting the tilt angle, i have a screenshot of the diagnostic window,...