Separate names with a comma.
Overshooting or not?
Do you know if there is a way to find if a oscillation of the gimbal is due to a over or a under gain?
I mean when Roll...
I don't really have problemes with my Radians but I am sure it's possible to improve it.
I think that's could be better with Roll tuning...
Yes, that's what I say: this product is getting dead .............
You don't think it may be improved ...... a bit, a lot?
Euh, no, I was asking about a Radian upgrade.
Do you have intention to make a new version after this 1.03.
Seem to me that this product is a (little bit) dead! Don't you?
I just hope you are not joking. That will be too great a such feature. :)
I completely agree with John Fox when he said:
"The problem with a single board controlling all 3 axis is the complicated mathematical equations...
Don't keep these messages but I send my messages to firstname.lastname@example.org.
New version features:...
I have buy a Hoverfly gimbal about 2 month ago.
What can I say:
Some calibrations are necessary; and you have to frozen and let get warmer to...
Again, thanks for all.
Could I say that, in my point of vue, this is not the best way to make some slew angle.
I think the most natural...
Yes, you are right, that unfortunatly his normal behavior.
Not a too big problem, but I think that's not the good option.
As I can see, it's easy to get the tilt level at start up.
With the Software connected, make very small movement down on your stick and you will...
I am really sorry all of that dont change some thing. Always the same: angle change until I go back with the pot.
To simplifly, I...
I get the same problem if I supply power to port 2.
But I don't have a loop back between roll and tilt; just a connection from port 3 tilt...
Tilt Radian connections:
1: Receiver to angle change (Via pot) without red wire.
3: Go to Radian Roll
Thanks to reply.
What I do is to connect a receiver output (that is commanded with a pot) to Radian tilt input 1.
I do that to change...
I put a potentiometer to adjust my tilt angle and when I make a move with the pot, angle increase or decrease but the movement don't stop until I...
I have also some problem with XP:
- PC Software 1.0.1 is installing and run well.
- During Setup of Bootloader programm I get the message "Setup...
Don't forget to upgrade your GR24 too.
You must use version 33512_gr_rx12_3a70_bf.bin and (version 1v126.bin for your MX20).