Separate names with a comma.
Wire Vibration Isolator (Without Toad)
$500,- WW Shipment
Yes. i have one you can use. You can PM me
Including handle bar: 12 lb (5.5 kg) :confused:
The molds are very expensive to make. So if it only differ 1.5 degrees. I would try the 9,5 first.
So far really happy with the flight...
Would be interesting to know what the m600 angle is?
Same here. Also thought that auto filters would solve these issues.
Maybe the firmware needs fine tuning.
I do not own the Pro. Still on the M15 with v4.02. I know that settings are not comparable.
But did have similar results with standard settings....
Did you test with a lower gyro filter?
Hmmm. Not sure what to advice. maybe others can chime in.
I like them to be a little flexible. So they damp minor unbalance in prop/motor....
1mm for flat config is fine. min 1.5mm for coax.
9.5° dihedral are 1.3mm, don't know how they hold with coax config
On set today with 18 knots wind speed. Surprisingly rock solid. Almost no movement in Gps. Not flyable in gps with old setup. 5% loss in lift....
I have to wait. Still - 5c atm. Let you know when i have more info
Also using the Sena Tufftalk. Nice set
Atm it to cold to do more testing.
Btw Ozkan is using the swan neck arms. I have installed the 9.5mm bent tubes
Would be nice to know if the new O=rings from the Alta are the same size.
Using 8x Blue for 6.5 - 8kg
Blue and Red...
I have one. pm me if your interested
Btw they are 1.3mm. So 25 x 22.4
The supplier told me this is his new site! The one i ordered from is the one Mark posted...
To get better position hold i used the holiday to do this carbon boom upgrade with 9.5° dihedral tubes.
Although i think 5° would be enough. I...