Separate names with a comma.
I have a problem with 2 of my modules (Tilt / Pan)
Tilt: Can suddenly no longer operate so high down (2x mode on / off again Okey)
Release date? I need it ;)
Octocopter with GR-24
3-axis gimbal with GR-24
Is it possible that only 8 channels can be used?
I have a GR24 but there are only 8 channels displayed (SUMO-12), channel 9-16 are the...
The problems are receiving loss
Anyone have a solution for the problem mx-20 hott / mx-12 hott.
I already have problems after 50 meters.
Someone of this configuration is...
Thank You Andy, sorry for my English :)
If I turn off the transmitter MX-12, the modules switch on STABILIZED SLEW.
See in the picture.
I have now tested 3 modules individually ...
Each Radian is activated as soon as I put +5 V. Only Servo(Port4) and +5 V(Port1).
I have now switched OFF the File Safe on each channel. The same problem
When I use the Radian without receiver, attached directly to...
When i Tunr OFF my Graupner MX-12 with GR-16 (FailSafe) Turns the Radion ON. FailSafe settings I've actually done.
Connected via PPM.
I have tried several times until I had it.
I have also connected the CamRemote-2a and the NEX5, works great.
You have the right switch trim in my MX-12 I have 88% and 88%.
These steps have been performed several times, unfortunately without success.
With the other two Modules, it works without...
Thank you for your Help :)
I hope Tabb or JoneC can help me, with this Problem
First, the problem with the FreeFlyUSB and now...
When i connect to the Power it's the Radian on the table.
I have two Modules without Problems on any position (Pan, Tilt, Roll),...
I have a problem with a module.
2 modules which are OK behave like in this video
1 module that is broken is like in this video
I have a Problem
I can not plug in the USB connector, at the corners, it still has tin.
or I have a wrong usb connector (microUSB)?
Works the Radian-System with Futaba BLS451 Servos?