Separate names with a comma.
Thank you Andy
A veritable cornucopia of options and idea's. Very nice thank you.
I hope all is well with you.
Thank you Andy,
A while back when we first tried using the Controller for aerials I also was very disappointed. When I contacted Freefly I was...
I would as well, given that it was sold as having the that airborne application in mind. The range simply isn't there currently. Any help in...
We have the same issue and even when trying to use it on a full sized heli. When we go into a turn, however slight, the M15 breaks free and/or...
I found that if I didn't release the bind button, the led would turn solid Orange but never blink until it was released.
There mightt be a firmware or instruction discrepancy.
These are the changes that seemed to work for me and might help someone else.
But when I followed the instructions with the Mimic, it didn't work.
I did it this way and it ultimately works but then releases it bind....
Ok, this is getting strange.
Following the instructions to bind Mimic to receiver was not working.
Never got a fast or a slow blinking orange...
Can you share how did you reinstall Mimic firmware??
Did you ever get any real solution? I think I'm experiencing the same problem and it won't bind or even blink orange, fast or slow.
I have been trying since yesterday to make the mimic work with the M15.
In looking at the forums, I’m not the only one with the blinking...
Would a different antenna on the controller help?
Perhaps a patch with a higher DB Gain?
Did you switch out the cable that goes out from the bottom of the camera tray?
Can you shed some light on when the Movi Controller will work with RT Motion?
Thank you! All good now.
My MoVI M15 did not come with a radio controller and I learned later that it doesn't. Is it possible to use a Spectrum DX8 and if so can someone...
Also will you be doing a sister case for controller, accessories and spares?
I'm in the same boat. I have a number of large pelican cases with gear I no longer really use. 1650's and others.
Will the custom cut foam be...
That would be great, thank you.
Thank you Andy