Separate names with a comma.
Yes... this happens.
You have torn the pads off the PCB and permanently damaged the unit. it is not repairable.
The issue is the weak and poor...
Here in Michigan, Generally - we use the 3-mile / 300alt / 900ft out rule.
We have contact the Airports, gotten permission / approval and...
Did you get support for this job ?
Yes, we have also had this issue ...it is Spektrum Rx .
We hallways had an issue in the "input channel monitor" screen. If the wires are not at...
I'm very interested in the conversion kit as well. I was looking to design my own kit...
Let talk about the parts you need, because I have a huge...
We just mounted a RED Epic Monday.
200mm boom arms,
Dual Bearing Tilt Axis to replace Pot
Longer drop tube,
2 of the metal boom clamps @ Longer...
We have had a HUGE issue with our Radian's on cold days.
The issue is only with the TILT axis.
Every time there is an issue, we will loose static...
If you missed it, I made some PolyCarb mounting plates for the CS8 that allow for a Hungry Power systems distribution unit, as well as...
Our rig has Castle Creations 75A ICE lite ESCs .
We have had great luck with the ESC program set to Medium startup, while keeping the WK-M Idle...
We are looking for an improvement in Michigan's gusty and unpredictable wind conditions.
Wind speeds here are consistently 10-15+ ( MPH ) every...
Sweden looks like American College Bars ( where the girls are at )... UK looks like American Sports Bars (Jocks - Ugh ) ..
Consumables are as listed
3 of our motors are staring to show signs of wear. I'll...
Sounds like the kind of crash(s) that made us change from MK to WK-M.
Hope you get it back up to speed ASAP.
We have searched extensively and haven't found a good info,
We are looking to to capture reasonably fast automotive movement,...
My Camera Op ( and Business Manager / Partner) and I will discuss and get back to everyone with our input.
While it the Radian stabilizer can give good results, its not great on a CS8 OCTO in higher winds.
*note, we have tried alot of the setting...
There are a few questions I have, or items to note that i didn't see in my quick scan of the thread.
We had a few issues with hardware vibrating...
Did you check / are you sure you COG and IMU/GPS mount locations are correct ?
Also check your ESCs. Do they have a control interface ?
In our limited experience, we have also been very happy with the APC.
New CarbonFiber props will get a trial today.
We need to decide which remotes to use.
Currently we have the following to pick from:
- Graupner Hott MX-20 2.4GHz 12 Channel / GR-24