Separate names with a comma.
Here's my set up:
Y6, KDE 5215 330kv, KDE 55A esc, Tmotor wood 20x6(top), 20x8(bottom).
It flies very well in high wind
2X pulse 6000mah35C. With...
Hi Alex I.ve been using 40
I've been using coax, WKM + Tmotor 4014 330 kv for 3+years.
For lighter set up(GH4)...
Merry Christmas & happy new year. Thanks for every advice
I will try CP soon, I will convert all my mr gimbal with retract
Can you share your opinion about phobotic centre piece? also in comparison with alex Mos?
I ordered one, but it will arrive end of Dec/Jan
No, pilot mistake. I forgot to put 1 observer in small alley, difficult manuver. split second late and boom hit gig tree.
Small clap might looks...
This is now, my drone crashed.
But the good things about DIY equiptment [ATTACH][ATTACH][ATTACH][ATTACH][ATTACH][ATTACH][ATTACH] is, you can...
Agreed, that was then. tq for your concern appreciate it
iPower GBM 110 Installed-pan axis. a lot of torque!
Just arrived, Ipower GBM 110-150T. 11 inch diameter 554 gram, max torque 11.5 kg.cm. I will put it for pan axis
My recomendation : first review & fix the structure flaws & test it. If it flies better, then you can fine tune with software.
Vibration to center...
Vibration might come from propeler wash to your landing legs. Longer boom arm are better to minimize it
Wow, thats BAD!!! Ballet in the air
Im sure you are in right decision to M5.
Compare to this..
This is my pan modification using belt drive. Vibration come from center gbm motor/pulley. Also big lag respons during pan.
I might missing...
What is the best solution to lift RED?
Using 3 Iflight 8017 on 3 axis? or 2 IFlight 8017 on roll & pan + 2 Iflight 5108(200T) on tilt? Which...
Wich one? In shooting tanker I use regular cinestar extension leg. On my pcit profile I bought from famous hobby.
Yes, I agree with you Bill. it...
3 month ago on this set up(5D+Cinema lens 15mm= 2.5kg), Im using 3S 1000mah battery. Gimbal should balance perfectly, it can tilt down 90 degree...
last week i put cinema lens(1.2 kg) on 5D. it work well. Im using 4s, upgrade motor with 200T on roll and pan. Tilt using 180T