/dist/images/branding/favicon

GPS antenna solder points on M15 mainboard snapped

Discussion in 'MōVI M15' started by Andreas Kielb, Oct 28, 2018.

  1. Andreas Kielb

    Andreas Kielb New Member

    Joined:
    Apr 28, 2013
    Messages:
    8
    Likes Received:
    2
    Hello,

    unfortunately the GPS antenna solder points on my M15 mainboard snapped. All three contacts are stripped of the board so there is nothing left to solder a new SMA jack too. The Movi M15 still stabilizes well but of course shows zero satellites. How difficult would a replacement of the mainboard be? Is it possible to order just a new board without having to send the complete gimbal in?
     
  2. Andreas Kielb

    Andreas Kielb New Member

    Joined:
    Apr 28, 2013
    Messages:
    8
    Likes Received:
    2
  3. Andy Johnson-Laird

    Andy Johnson-Laird Administrator
    Staff Member

    Joined:
    Jul 31, 2012
    Messages:
    10,383
    Likes Received:
    1,164
    Andreas, if you've not already done so, I suspect you should open up a ticket by sending an email to Freefly Support (support@freeflysystems.com).

    Regards
    Andy

    Forensic Software & sUAV / Drone Analyst : Photographer : Videographer : Pilot (Portland, Oregon, USA): Trees=2, Ground=1, Props=11. :(
    The Ground Is The Limit™
    ---------- Forensic Drone Analyst : Forensic sUAV Analyst : Forensic Unmanned Aircraft Analyst : Forensic Drone Expert
     
  4. Andreas Kielb

    Andreas Kielb New Member

    Joined:
    Apr 28, 2013
    Messages:
    8
    Likes Received:
    2

Share This Page