Hi All, I have a problem that may be something simple that I have overlooked. I have a Movi M5 with new, fully charged batteries that I have successfully bound to a DX6 Controller. It shows no warning pattern on the LED lights yet the controller has no effect. It shows on the app the commands are being read but there is no movement in Movi with stick inputs. I have switched between modes on both the app and the mode switch on the controller, to no avail. Any suggestions?
you need to map the channels you want in the movi settings under "Remote Controller Config Menu" to the corresponding sticks movement of the dx6. read page 30 of the manual http://d27w8s76bjlz9v.cloudfront.ne...2014/07/04002153/MoVI_M5_User_Manual_v4_2.pdf
Hey Jason, Thanks for your reply. I've actually already mapped the controller and it shows the inputs on the Movi app.
Well then the next thing is to check all the cables are properly seated. I had a one come loose when i was setting up mine. I had to take the 4 screws on top the lights and replug the cable back in. You didnt say if it was working without the remote?
For some unknown reason, re installing the firmware worked and it's operating normally now. Thanks for your input Jason.