/dist/images/branding/favicon

MōVi Controller in DSMX 2048 Mode to operate other things

Discussion in 'MōVI Controller' started by Jan Evers, Jan 19, 2015.

  1. Jan Evers

    Jan Evers New Member

    Joined:
    Feb 5, 2014
    Messages:
    22
    Likes Received:
    3
    Hey Guys,

    I'd like to use the MōVi Controller with other gimbals and accessories. I found in the manual that you can put it in DSMX 2048 Radio Mode. In this mode the MōVi Controller Receiver should output a Spektrum DSMX 2048 satellite receiver signal via the 3-pin Spektrum connector.
    Does that mean, that it acts as a satellite receiver? So I can connect via the 3 pin wire a normal Spektrum Receiver where I can get the normal Control Signals from the Servo Connectors?

    I hope that you can help me out.

    Kind regards

    Jan
     
  2. Gary Haynes

    Gary Haynes Administrator
    Staff Member

    Joined:
    Jul 6, 2012
    Messages:
    5,211
    Likes Received:
    460
    Jan you are correct. But only the Sat Receiver, not a standard Spektrum that has servo connectors.
     
  3. Jan Evers

    Jan Evers New Member

    Joined:
    Feb 5, 2014
    Messages:
    22
    Likes Received:
    3
    So what is the sense in of the system when I cannot connect a standard spectrum receiver to the movi controller receiver?
     
  4. Chris Jordan

    Chris Jordan Member

    Joined:
    Dec 4, 2013
    Messages:
    118
    Likes Received:
    16
    Can this be done with a spektrum satellite on the Movi? Movi controller to Satellite instead of movi controller receiver?
     

Share This Page