Hello, I apologize if this has been discussed before, I did search the forum. I have a toad in the hole on my M5 and when I use upside down I am getting a slight clunk or looseness in the toad. It is ok when used in the normal orientation, but with the gimbal reversed, it clunks. I have tried a couple of different male connectors, but it still does it. All screws are tight and I tightened the lever as much as I could with it still going over centre to lock. Any ideas? Thanks Andrew
Hi Andrew: I suspect the best thing to do is open up a support ticket by emailing to support@freeflysystems.com -- I don't recall the issue you're having as being reported on the forum. Andy ---------- Forensic Software & sUAV / Drone Analyst : Photographer : Videographer : Pilot (Portland, Oregon, USA): Trees=2, Ground=1, Props=11. The Ground Is The Limit™ ---------- Forensic Drone Analyst : Forensic sUAV Analyst : Forensic Unmanned Aircraft Analyst : Forensic Drone Expert