Hello everyone i have buy me a futaba T14SG AND RECIVER R6303SB a have bind it togthere and i have all green led in con software i cant understand to get it mapped like the spektrum came with the m5 is there anyone that can explane to me what to do in the radio and software please? thanks
Hello Kjetil, Have you changed the "Radio Type" to: SBUS ? There is info in the is manual-- http://www.quadrocopter.com/assets/templates/quadrocopter/downloads/FFS_moviManual-v1.pdf See: 04-P24 Greetings, Adam
yes i have set it to sbus is iy just to type in the mapping for futaba that is in the manual?? i have made a new model in the radio,bind to the reciver and it is ok,i have pugg the reciver to the movi with a servocable .do i need a special sbus cable? do i have to do something else in the radio??
Kjetil I think just plugging your RECIVER R6303SB straight into the movi with a servo cable may not work? You may need to have s-bus PWM Adapter but I am a little confused myself. IF you have a green light in the software you may be ok. go the remote controller config menu in the software then with the movi in the stand power it on. (thats how i did mine) then change the numbers slowly until you get the right mapping to your controller. http://d3k6epckf0kum1.cloudfront.net/wp-content/uploads/2014/07/FFS_M5-Manual.pdf page 31
A standard servo cable is fine. Futaba uses a keyed connector so orientation is important. Then follow the mapping of the Futaba that has been mentioned in other posts. Others have shared their mapping which also needs to be done not the 14SG.
hello i get it rigth because off what you wrote (change the number slowly until you get the rigth mapping for your controller) thanks now it work fine with my sbus futaba T14SG