/dist/images/branding/favicon

Servo Port ? For use of another channel on DX7

Discussion in 'MōVI M10' started by Justin John, Jul 11, 2014.

  1. Justin John

    Justin John Member

    Joined:
    Jun 29, 2012
    Messages:
    54
    Likes Received:
    10
    Using the M10 in handheld and on a multi rotor. I've made a remote trigger cable so I can trigger my record on/off on the red camera. This would work with your typical Spektrum servo port receiver. I'm using a spectrum satellite receiver and was wondering if the movi has a servo out port?

    Looking for suggestions to get access to another channel from my DX7 transmitter.

    Any suggestions on a solution / work around ?

    Thanks
    Justin
     
  2. Justin John

    Justin John Member

    Joined:
    Jun 29, 2012
    Messages:
    54
    Likes Received:
    10
    I'm going to try splitting the satellite receiver cable to go into both the M10 and a spektrum Servo receiver.Hopefully this will give me the extra port i'm looking for. Just wondering if it will supply the 5v from the M10.

    I'll post my results after i'm done
     
  3. Steve Maller

    Steve Maller UAV Grief Counselor

    Joined:
    Oct 30, 2012
    Messages:
    3,981
    Likes Received:
    807
  4. Justin John

    Justin John Member

    Joined:
    Jun 29, 2012
    Messages:
    54
    Likes Received:
    10
    Thank you! Very helpful
     

Share This Page