Hey guys, I have a cinestar 8 with a dual operator set up. My second receiver and transmitter, for the gimbal, came unbound I think and I was wondering if you guys could help me get back my gimbal control. I think the problem was that the set button on the one module was held down. If you guys could give me some advice that would be awesome. Also do you guys know if graupner has tech support in the us? Thanks guys
HI Chris To bind the RX (receiver) to the TX (radio) first make sure you turn RF off on the radio. Then go ahead and press while holding the set button the RX and then select bind on the TX through the menu selection. You also want to make sure your channels are summed with the selecto SUM 08 in the telemetry menu. It can sometimes be a little tricky so it might take a few times.
http://www.mikrokopter.de/ucwiki/en/MX-20 At the receiver now press and hold down the button "SET": Receiver GR-12 => hold down "SET" button. Receiver GR-16 => hold down "SET" button until the red and green LEDs light together (maybe difficult to see that clearly). Receiver GR-24 => hold down "SET" button until the red and green LEDs light together (maybe difficult to see that clearly). Press "SET" within 3 seconds at the transmitter (in the row "RF BIND) "Finding" appears in the display for a short time. To get to SUM 12 Switch to the menu "RX SERVO TEST" by pressing "right" 5 times. INFO: If you have clicked to far and you see the MK-Menu you can remove the 1-core telemetry plug from the FC to get back to the page "RX SERVO TEST". I couldn't get to SUM 12 last week because the telemetry was plugged in: So: You can't get to the "RX Servo test" IF the telemetry is plugged in.....IF you went past it the first time...
One of the USA Graupner vendors answers questions on this forum: http://www.rcgroups.com/forums/showthread.php?t=1330285&page=24&pp=100#post28153421