/dist/images/branding/favicon

Radian Inactive.

Discussion in 'Radian' started by Chris Schuster, Sep 22, 2012.

  1. Chris Schuster

    Chris Schuster New Member

    Joined:
    Sep 22, 2012
    Messages:
    18
    Likes Received:
    1
    One of our three Radian controllers suddenly went inactive. When connected to the config software the readout in the left hand box of the "current-angle-damand" window will count up to the max value and then start from the lowest value and count up to the max value again and again, over and over without stopping. All with no output to the servo. This is regardless of mode switch position. Resetting to default values does nothing.
     
  2. Josh Lambeth

    Josh Lambeth Well-Known Member

    Joined:
    Jun 29, 2012
    Messages:
    1,315
    Likes Received:
    216
    What voltage are you running everything at? Did it do it while flying or on the bench?
     
  3. Chris Schuster

    Chris Schuster New Member

    Joined:
    Sep 22, 2012
    Messages:
    18
    Likes Received:
    1
    5.5 volts had about 1.5hrs of running time on the bench
     
  4. Tabb Firchau

    Tabb Firchau Administrator
    Staff Member

    Joined:
    Jun 28, 2012
    Messages:
    911
    Likes Received:
    472
    HI Chris, I sent that one with a self destruct packet installed ;)

    only kidding did you figure out the issue? I have not seen anything like this yet.

    Tabb
     
  5. Chris Schuster

    Chris Schuster New Member

    Joined:
    Sep 22, 2012
    Messages:
    18
    Likes Received:
    1
    Tried everything i can think of and cant get it working but the other two are wonderful !
     
  6. John Cunningham

    Joined:
    Jul 5, 2012
    Messages:
    183
    Likes Received:
    13
    Chris,

    What are the LED's doing ?. The IMU does a fairly thorough self-test and he orange one will flash slowly if there is a fault.
     
  7. Chris Schuster

    Chris Schuster New Member

    Joined:
    Sep 22, 2012
    Messages:
    18
    Likes Received:
    1
    Hi John;
    The orange light stays solid after initialization.
     
  8. John Cunningham

    Joined:
    Jul 5, 2012
    Messages:
    183
    Likes Received:
    13
    OK Chris,

    Does it do the same thing if you disconnect all cables except for power and the PC-cable ?
     

Share This Page