Radian set to save all three of you can not. (Write-> timed out) One initialization failure of the lamp to work. "Green LED slow blink = Motor drive off (or drive initialization failure)" Link to the video's so hard to explain in English. install pc : win7 64 bit and win xp 32bit using usb cable - dji wk-m data cable and samsung galuxy s3 data cable spektrum dx7s and ar8000 input v : 5.5v help me...........
You have to change your Regional Settings in Windows to Unicode or English. Once it's done It's possible to write on the Radian. Try contacting Daisuke Ide here in the forum. He had this problem and found the answer.
Thank you. This problem has been fixed can not be saved. But I do not still green led blinks and initialization protocols. roll and pan will work fine.
Do you mean the pan does not work ?. If the green LED is flashing quickly, the IMU is initialising. The mount needs to be still while it does it : it will hold-off until it detects it is stationary for > 1 second. If the green LED blinks slowly, it means the motor drive is turned off. This can be because of: 1) The servo is disconnected or does not have the resistors fitted instead of the pot 2) The radio is 'on' and it is selecting 'Fixed Position' (Pan axis only) or 'Off' on the mode channel.
I just created a thread explaining how you can check the Radian orientation : can you check your tilt axis please ?.
Do not know English, it is difficult to understand. You talking about the content of the below is correct? Currently using a satellite receiver connected to the S-Bus, the movement was very tender. roll pan axis and the axis it works so well. However, the tilt axis is still there will not be initialized. green led slow blink Calibration was attempted.
Holy cow : how did you get the calibration screen up ?. What exactly did you do on there ? Edit: I just realised the software release has some development options enabled (such as the calibration window). Please everyone, DON'T WRITE ANYTHING TO THE CONFIG using this window : only use the windows which are described in the instructions. Clicking things on here can mess up the IMU calibration. The PC software for download will shortly be replaced with a new version which stops you doing this by accident ...
OK - when you move the tilt axis by hand, does the value on the left-hand side change ?. Try (for example) moving the tilt 45 degrees up and check it says roughly 45 then 45 degrees down and it should say around -45. Remember to unplug the servo before you do this.
Exactly what you mean, I did not understand, This means supposed like shooting video link. http://youtu.be/XSP0nQuEdwg It's too hard to talk in English .....