Hi, I got a 2 axis CS gimbal with radians, one GR24 to the FC board and one Spektrum Sat to the roll radian. I would like to know if it was possible to connect the roll radian to the GR24 (or to the FC) for "On or Off mode" and the tilt radian to the spektrum sat. Or maybe is it possible to add a mode (with a combination of switchs on the transmitter) Off Stab Stab with slew (Stab Roll and Tilt) Stab with slew (Stab only on Tilt) Thank you for your help.
I just want to be able to turn ON or OFF the roll stabilisation keeping the tilt stabilisation and slew ON.
No need to feel dumb. Just remember you're not as dumb as I look. We all get mental blocks and can overlook those "Duh! (Slap palm of hand on forehead)" moments. Andy.
Yeah, you must be right! Of course the "separate channels stuff" works fine. But what about if I want to be able to switch between Dual pilot setup and Single pilot setup. I read a lot of topics about it and this one kept my attention: It seems to be easy, but I don't know how to set this up. Maybe am I searching to far (again)?
It's midnight, I'm tired but I want to resume my situation at this time. If dual setup mode: Pilot -> MX20 -> GR24 -> FC (Sumo via Output8)Co-pilot -> DX6i -> Spektrum Sat -> Roll Radian -> Tilt RadianRoll Radian powered by a 2S lipo via 6VBec."Separate channels stuff" for modes control.If single setup mode: Pilot -> MX20 -> GR24 -> FC (Sumo via Output8) -> Roll Radian -> Tilt Radian (MX20 input 9 -> Ctrl10 and Tilt Radian Slew = 9)Roll Radian powered by GR24. It seems to work fine. I just need a test flight (tomorrow).