Separate names with a comma.
Wire Vibration Isolator (Without Toad)
$500,- WW Shipment
Yes. i have one you can use. You can PM me
Including handle bar: 12 lb (5.5 kg) :confused:
The molds are very expensive to make. So if it only differ 1.5 degrees. I would try the 9,5 first.
So far really happy with the flight...
Would be interesting to know what the m600 angle is?
Same here. Also thought that auto filters would solve these issues.
Maybe the firmware needs fine tuning.
I do not own the Pro. Still on the M15 with v4.02. I know that settings are not comparable.
But did have similar results with standard settings....
Did you test with a lower gyro filter?
Hmmm. Not sure what to advice. maybe others can chime in.
I like them to be a little flexible. So they damp minor unbalance in prop/motor....
1mm for flat config is fine. min 1.5mm for coax.
9.5° dihedral are 1.3mm, don't know how they hold with coax config
On set today with 18 knots wind speed. Surprisingly rock solid. Almost no movement in Gps. Not flyable in gps with old setup. 5% loss in lift....
I have to wait. Still - 5c atm. Let you know when i have more info
Also using the Sena Tufftalk. Nice set