Separate names with a comma.
I plugged in a connector to the mode port not connected to anything, flashed it up and all was norma, roll axis drove to level....hmmm then just...
Yeah, I guess if ever actually need to turn stablization off, may as well be switching off both tilt and roll. as I will be running a parallel...
connected mode cable to roll unit, works as expected, disconnect mode and it still does as previously described, weird as the software shows the...
No Andy I haven't done that yet but I shall, really just had time to connect up to PC and check the mode status before going away for work for a...
I think as long as it fires up in stabilized non slew mode, that should be fine for me, dont really have any need to slew the roll axis or disable...
Is Freefly going to release a brushless mod kit for the Cinestar 2x/3x? bearing in mind the similarity in basic construction between the Cinestar...
I should explain, I dont have the roll set up for switching modes or slew as I do the tilt unit (no free Rx channels).
Thanks Gary, I will check it out, I'm sure it starting up in mode 1 as it is actively stabilizing...just around a false datum unless I level the...
Not sure if this is by design or not but every time I start up my radians the roll unit will set its datum at whatever position the gimbal roll...
Hi, I'm Steve from the north of Scotland. ex naval a/c tech, licenced pilot (ppl), and currently working as ROV pilot/supv. Trying to develop...
