Separate names with a comma.
Did you solve your issue? Check the voltage of the batteries (there are many ways, most of them cheap), or even try to charge/balance them using a...
Hello, I own a Freefly MoVI M5, but this should apply to any MoVI. I recently changed my smartphone, and when I connected it with my MoVI via...
Indeed it could, and it should be very easy. I hope Freefly listen to us. I'm in talks with them about the issue. Let's see what we can do.
Bryan, thanks a lot for the replies. I asked via email a week ago, still haven't received an answer, then I came here to the forums just in case...
Bryan, the problem is the Park mode doesn't leave the yaw axis in the correct position (and not strongly enough, it's easily disturbed). If you...
Same problem here, I love my M5, but this one issue makes it imperfect... The yaw axis SHOULD be firmly locked by the motor while on the floor...
The drone should stop spinning not by killing the motor (which could leave the drone too loose and could move before or while taking off, which is...
The “Park” mode isn't holding strongly enough the yaw axis to avoid undersired movement before or while taking off. Also, it's drifting...
I sent this question to the Freefly guys three days ago, and they still haven't replied yet (they usually don't take more than a couple of days)....
When I plugged the Futaba receiver on my M5 and started configuring the channels and moving the pitch using the transmitter sticks, I noticed...
I tested a new S-FHSS S.Bus receiver for my T6J and it works perfectly. I also tried a FASST S.Bus receiver (R6208SB) with the T8FG transmitter,...
Hello, I have a pretty relevant doubt which the Freefly support didn't really know how to answer (they are good, but not with this one :p). I own...
