/dist/images/branding/favicon
Separate names with a comma.
Well said Cedar and all. I was on Vimeo and saw this very irresponsible FPV flying video just posted. [media] This type of FPV flying, so close...
Hi Bill, Been reading your posts here (and other forums) with interest. Have you done much ground based testing and tuning of the CS gimbal...
Hi guys, Thanks to Brad's suggestion regarding the need to adjust for the vertical play, I did the same on the QC3328 motor. In doing so tonight,...
Thanks Andy. Yes was going to try those#7s, but I thought I would try #5 as they should be adequate for purpose. Guess not perhaps, I sure did...
Hi Josh, What has happened since this last update? I also am frustrated with replacing bearings and then having more shaft movement than before...
OK. Thanks Gary. I have ordered the install kit this evening from Bart. It sure looks like it makes the changing of the bearings much easier with...
Gary, I went onto to McMaster site. Placed order last night and today received this email: "Due to the complexity of U.S. export regulations,...
Thanks Gary. Sean
Yes me too. I just purchased 8 of the QC motors last December. I have now had say maybe 20 flights max... and have at least 1 or 2 bad motors...
Hi Brad. Looks fantastic. I saw your nice video from Scarlet at the same location on vimeo. Where is this location? I'm in North Vancouver and...
Nathan, OK good to hear to found the source of the problem. Cheers Sean
Hi Nathan, I'm reading this on bus on iphone so perhaps missing the exact setup being used, but perhaps try this. When you plug the servo into an...