/dist/images/branding/favicon
Separate names with a comma.
Thanks for the info, Phillip... It helps to know others are experiencing similar issues, I was hoping there was something I was missing,...
Gary- Thanks for the response! We've done 1 and 2, that's how we verified that we had mostly eliminated the oscillation... Prior to that there...
Radian on a 3-axis cinestar gimbal, latest 1.03 firmware. Savox on pitch, FF servos on pan and roll. Camera balanced without belts on. We've had...
Sooo... After all that, I tried setting 1024 on the tilt unit (was doing it on Pan before) and it seemed to work immediately. So I must have been...
John- Yep, I definitely did... When 1024 was enabled I got basically no channel values, and the Spektrum Valid indicator never toggled on. So...
Thanks for the response! I've never used 1024, as I always get basically no "Spektrum Valid" connection and no values in the input monitor, as I...
Gary- The sticker inside the receiver on one says 7224, the other says TA807B. The latter is the satellite from an AR 7000, I believe the former...
So this may or may not be related to 1.03, but since no one else has reported it I thought I'd start a new thread... I updated the firmware on...
I haven't been able to get PPM working with mine at all... I tried a DIYDrones PPM board as my receiver doesn't have a PPM out, and I got the same...
Any chance your radio was commanding a roll to the radian? Did you check the slew indication on the roll module using the config software?
That's correct. I have my shutter on the Pan unit because it's a better wiring option, so I set up the Pan unit to output channel 6 on AUX. If I...
I don't believe the Radian acts as any kind of voltage regulator, so if you put in 12V it's going to pass that along to the servos, which you...
A better solution for this is to use the Aux output of the radian to control the shutter... Just connect the radian unit closest to your camera or...