Separate names with a comma.
Ok cool I will get the app and give it a test thanks for the info and the help. 1 more question when I line up the tips of the propellers not all...
Hi all its been a while but I started a new show and have been working so I didn't get to fly till today. I went flying and made sure everything...
Ok copy that thanks this helps a lot. And I'll watch that video Thank you again justin
Copy that guys I have taken the gimble off and this morning I'm going to go back through and level everything again and thank you about the acc. I...
thank you i will do the tip thing first but i dont think i explained the foreward motion correctly its like i am pusing the right stick foreward,...
thank you all for the replys ok so got it running all is good but... and there is a but, i went through and checked level on everything before...
it was just a thought from some of the things i have been reading around the boards.. (so much info out there)ill take it out and see how it does...
one last question to all if i need to set idle lower for my cinestar8 how would i do that in mktools?
k i think i got it they are spinning slow but not super slow dont know how to explain it but when i throttle up it (the motors) spin alot faster...
so they sould be running (i.e.)turning when throttle is at 0 and yes the motors do spin faster when i throttle up . so on my msc tab the min gas...
k i got the motors to start but when the throttle is at 0 on the dx8 they are still running, and the misc tab boxes are as follows compass error...
ok so I got them running but now when I start the motors they just run at a slow rpm when the stick is at 0 and when I throttle up they go up they...
thank you gary that is my first name just didnt put my full last name but will do it. now yes all the chanels are all moving the same on the...
hi andy i am new to this but i cannot bet my motors to run with my dx8 i see it working in the mktool but when i unplug i get nothing i have...
