/dist/images/branding/favicon
Separate names with a comma.
Any advice on where does he 3dr telemetry tx radio should be connected on the MK flight control board (or is it on the nav ctrl board)? Thanks
You're absolutely right Andy, and thanks for your input. I've been flying a Cinestar 8 with a camera gimbal for three weeks now (mostly on...
That's a great diagram, thank you very much Adam, it makes everything a lot clear and easy to wire. However I don't quite get what's coming out...
Thank you Gary, I'll try to figure that out with the MX-20 and one rotary knob. I'm not using come home at the moment, so I could use a three way...
Good afternoon. I'm thinking on building a single operator setup on a 2 axis gimbal with Radian stabilization for a Cinestar 8 frameset. The only...
Worked with that value unchecked. Thanks Gary.
Well, I have the same problem as described by Sean. Checked the cables and followed the procedure exactly as the Quadrocopter video explained, but...
ok. For tilt I have channel 2 (right hand stick un and down). For Pan channel 1 (right hand stick left and right). And for roll channel 3 (left...
Well Gary, perhaps this sound silly but I haven't been able to control the gimbal. As far as I'm concerned, I will use ANY control recommendation...
Gary: 1,2.) How do I map that control on the MX to channel 2? or any other to other channels? 3.) Thanks about that, now I know what values to input.
Sorry for the wiring. As soon as I have everything working out as it should, I'll clean up the mess.
Well guys, you're the best. So far, I've managed to successfully (or at least it seems so) installed and wired all radians to the system. I'm...
Hi guys, and thanks in advance for all your support. I'm now installing the RADIAN system for the 3 axis gimbal, but I can't seem to find a proper...