Separate names with a comma.
A new one for the Freefly team. I have a 120KV (more like 113kv) motor that I can run well in speed mode, except the arc fails to push enough...
Hi Matt Speed mode (RPM) is the correct mode to use. Your max theoretical RPM should be 32256rpm. So if you set the ARC200 higher than that, then...
Been a while so I thought I'd upload a few pictures... First the board: [ATTACH] [ATTACH][ATTACH][ATTACH] The ARC200 is attached to this...
Managed to find them...
I was wondering if the connectors on the ARC200 are Freefly designed or otherwise what type they are?
Thanks @Tyler Christensen that solved it! I can't wait to get my board back now so that I can put it all together and test it on the water!
Thanks for the response @Tyler Christensen Which RPM limit do I need to change in the config. The max RPM my motor should hit is around 37800 at...
Finally got the time to get a video. [MEDIA] - You can hear some strange scratching noises, not too sure what it is. Motor bearings are fine. -...
It appears that even though the failsafe was working on a different ESC, I did need to reset it for the ARC200. I managed to get it working...
I have upgraded to the latest 1.18 firmware, however the failsafe is still not working. If I switch off my TX or if there is a signal loss, the...
I haven't used the ARC200 on the foil yet, been hit with the flu pretty hard and waiting for my board to be returned to me. I have altered an...
I have had it in the water since July 2018, however I have taken everything apart so that I can service and improve some parts of the drive unit....
I have been luck enough to get an ARC200 to test on my electric hydrofoil! Currently it is pretty cold and gloomy in the UK and I am testing...
