/dist/images/branding/favicon
Separate names with a comma.
Thanks for that.. All worked a treat!
One last question.. To actually update the unit.. Do i have to (As some others here have suggested) boot up the gyro in a bootloader mode? cant it...
Thanks for that.. Ill give it a go.., ;)
But why limit the software to 12 ports? and set port 10 as the default, so i have to change it every time i open the sortware? Mine is always...
I cant update mine.. I need Com port 13 for my USB device, but the boot loader only goes up to 12?!?!?!? any ideas??
So the longbow servos wont work with the Radians?
Here is a link to a video i made.. The test is a little extreme, but it does show the problem, and the effect on the tip of the rule, is the same...
The servo we are using is not smooth enough.. The footage shows a "Judder" which we have tracked back to the servo its self..
Problem is, there $190 each, so a bit of a gamble if there not going to cure my problems.. Thas y im asking for other users experiances with...
Hi there, Im looking for an alternitave servo for my gimbal for all three axis, and im looking at the Longbow P1 Pan Servo.. Does anyone have any...
I havnt updated them yet.. But i did see the list of improvments, and none of the symptoms i have been struggeling with were mentioned. Is this a...
The camera is perfectly ballanced, and the servo is jittering without the camera on the mount.. The "Rough" sound is a gear noise i can hear,...
Phil, I have checked for this and the belts are all tight. The Tilt servo does sound rough.. Do yours all run Very smoothly? Im wondering if i...
I am Getting a small jitter on the tilt axis using the Freefly servos, Radian Gyris and a Canon 7D with 11-16 Tokina Lens. The jitter is visable...