/dist/images/branding/favicon
Separate names with a comma.
I will test out the beta today. I'm just sharing with others how we've worked around these issues in previous builds, if they aren't comfortable...
Does anyone else have issues with the FreeFly RED RCP cable not properly locking into place in Epic Dragon? The cable goes in, and functions, but...
I have had success with RedRock motors by doing the following. First thing when booting up MoviPro and Movi Controller, I load factory defaults on...
I have had success with RedRock motors by doing the following. First thing when booting up MoviPro and Movi Controller, I load factory defaults...
Have you made any progress with this issue?
Chris, Were you able to determine what burned up your motors? Do you know where you had your maximum torque value set to?
Your torque setting is at 1, the very lowest. Bring this up incrementally until the motor will calibrate the lens. Be careful not to go too...
I had an issue with having the maximum torque setting too high on the movi controller. My Heden motors were getting VERY hot. Turned down this...
Charles, have you received your unit back from Freefly? Any progress?
I'm getting on a call with Freefly this afternoon in regards to this issue.
Timm, This did the trick. Thank you. Turned down the torque value, and the motors don't overheat.
I've been having the same problems, plus so additional issues with our Heden motors and the Movi Controller. Seems to work about 10% of the time....
I've had a call into FreeFly since yesterday morning, emailed them yesterday afternoon, called back again this morning, and I haven't heard a peep...
Does anyone have experience with Heden fiz motors on the Movi Pro? Ours seem to be getting SUPER hot, just sitting idle. We're working with two...