/dist/images/branding/favicon
Separate names with a comma.
Gary,I agree 3.6v seems like the safe spot to run. Thanks for the help!
Steve, Just changed the Undervoltage settings in MK-Tool to 3.3 and ran a battery down. It went all the way to 3% before warning. Probably too...
Thanks Steve, Just checked the gpx file and there's nothing on the card. Not sure what's up with that either. I'm checking the mk setting now.
Steve, Thanks for the quick response. I am using MK tool and I'll check these settings. We've had several batteries on it and no bad cells....
Looking for help with the early warning voice system. We just recently upgraded firmware. Everything is working well but we get voice warnings...
Just a follow up: It was that easy. I am sure though that this is different in several ways than it was in Version 1 of the software. Wish they...
That could be it then. I'll calibrate it and see what happens. Hope its that easy. Thanks! Bob
We were having some problems with our flight controls so we upgraded the MK tools, FC and Nav software. After doing so I'm having a few problems...
Just tried out a new Radian and it worked perfectly. That's the second radian I've had go bad on me. Thanks for the advice Gary and Andy!
That's a good idea. I have an extra Radian module that I'll place in there for testing. I thinking at this point that it's the radian. Bob
Andy, I did have the Radian mode set to off. In the on position it acutates the servo when it flickers like that. So it's doing what it should...
All, As I turn the tilt control on the Graupner mx-20 (2-axis setup) all works fine for a while then the tilt starts acting erratically. I can...