That's covered in one of Tabb's videos that you can find here: http://www.youtube.com/playlist?list=PLlKTld1e-W1yImvdV5nuJ8rgNgtozfYnX It's the last one on the list. Let us know if you have problems. Andy.
Hello. I have a problem with the Pan, I have 8 cinestar, with electronic dji. Connect everything according to the manual and videos, hooked through ubus. With the connector's three steps (off, stabilized and movement) the problem is panning. 1 use the connector of three steps and it begins to shake Hola. Tengo un problema con el paneo, tengo cinestar 8, con electrónica dji. Conecte todo según el manual y los vídeos, lo conecté por medio de Sbus . Con el conector de tres pasos ( apagado, estabilizado y movimiento ) El problema es paneo. 1- uso el conector de tres pasos y comienza a temblar
In a 3 axis Gimbal, I can leave the pan without working with the Radian and roll and tilt with the Radian? But controlled by the cameraman?
Yes, you can easily manage only Tilt & Roll, without the Pan axis. All three axis modules Radian, absolutely identical and independent of each other.
I set up speed servo in RC transmitter using Dual Rates & Exponent. This can get very slow and smooth motion servo.
Andy, I've discovered was the vibration problem. Disassemble the pan servo, I adjusted the gears, grease it, adjust the strap. The sound of the gears is very soft now. Greatly improved the stabilization in pan and roll.
A doubt. The base is attached to the oktocopter, only with the, dampening brackets, I think that is something loose
En la programación de los radianes, "gain", eso sucede cuando el "gain" en el pan es alto, lo que he leido es que usan entre 50 y 80 de gain. Me pasó a mi y ahora con 60 va bien
Ok lo tengo a 100 y le baje en el radio los exponenciales voy a bajarle a 50 y de ahí subiendo de 5 en 5. Una duda el oktocopter va a la base solo con los dampers
Los dampers van fijos en el okto (cinestar 8) y luego al plato que tiene el gimbal mediante los separadores hexagonales de aluminio, la amortiguacion la hacen los o-rings que van en los dampers, la cantidad y la dureza de ellos dependera del peso de la camara que uses.
Gustavo: I had to laugh....Google translate translates "pan" as "bread." When programming radians, "gain", that happens when the "gain" in the bread is high, what I read is that they use 50 to 80 of gain. It happened to me and now with 60 going wellYes, typically, the pan gain needs to be much lower than tilt and roll because the "mass in motion" is much higher. Andy.
Hi Andy, You mind to tell the young people of the community Radian, basic recommended configuration settings on all axes, for optimal performance? For example: Pan: Gain - 50-60% Max rate - 60 Angle Trim - 2,55 Deadbad - 8% Roll: Gain - 90-110% Max rate - 70 Angle Trim - 1,00 Deadbad - 3% Tilt: Gain - 140% Max rate - 60 Angle Trim - 0,00 Deadbad - 10% Greetings to all those guys who get the normal and smooth operation of the entire system Radiance. What are your favorite setups?