/dist/images/branding/favicon

Carbon Plate 3 Axis Gimbal

Discussion in '3 Axis Gimbal' started by Marc BRACELET, Aug 16, 2012.

  1. Marc BRACELET

    Marc BRACELET Active Member

    Joined:
    Jul 10, 2012
    Messages:
    204
    Likes Received:
    27
    Hello at All....
    Right now, I work a lot on my 3 axis gimbal and I wanted to share with you a find that I have made ??do with a site that makes CNC cutting : http://www.1001copters.com/
    This is a Carbon plate 3mm thick which is fixed under the Gimbal and you can easily put a lot of electronics modules above.
    This solution is clean and nothing is in disorder on the gimbal.
    My Cinestar is quietly preparing while waiting for the new stabilization system radians.

    Cheers.:cool:
    Marc.

    IMG_2696s.jpg

    IMG_2697s.jpg

    IMG_2702s.jpg

    IMG_2704s.jpg
     
    Joe Azzarelli likes this.
  2. Harvey Mann

    Harvey Mann New Member

    Joined:
    Jul 27, 2012
    Messages:
    21
    Likes Received:
    1
    Very nice indeed! Very neat & protected hidden away up there :cool: Can I ask what the board on the left is for? power distribution?
     
  3. Marc BRACELET

    Marc BRACELET Active Member

    Joined:
    Jul 10, 2012
    Messages:
    204
    Likes Received:
    27
    Oh yes Harvey, on the left these are 3 voltage regulators for vidéo Tx, HDMI converter and other electronic board like antena tracking...The RX have a separate alim (little module on the left, right side, and it deliver 6v and 5A)...
    Thats ok i hope...
     
  4. Josh Lambeth

    Josh Lambeth Well-Known Member

    Joined:
    Jun 29, 2012
    Messages:
    1,315
    Likes Received:
    216
    Very nice! Do you have a link for that voltage reg?
     
  5. Marc BRACELET

    Marc BRACELET Active Member

    Joined:
    Jul 10, 2012
    Messages:
    204
    Likes Received:
    27
    Ok Josh,

    Voltage regulators ( on the left of my picture ) are from FOXTECH.
    The RX voltage régulator (For high output servos alim 6V / 5V and 5 Amp) on the right of my picture is from TOP MODEL.

    20100804249_wm.jpg 493.jpg

    I hope this help you.
     
  6. Harvey Mann

    Harvey Mann New Member

    Joined:
    Jul 27, 2012
    Messages:
    21
    Likes Received:
    1
    Thanks Marc, good job!
     

Share This Page