Please help.... I updated the Mimic to firmware V1.40 and my Movi is currently V5.0.2. Since updating it doesn't connect with the Movi and we are using it on Monday morning and heavily rely on it as the main camera. Can anybody please talk me through the binding process, I have tried several times but when pressing the receiver button on the Movi, it goes solid orange but doesn't flash slow orange, guessing it is not finding the transmitter, without finding it, it wont bind right..?? help....???? UPDATE: 1 hr later - So, fortunately I saved the previous settings on the Mimic prior to the update and I went back to them and the Mimic is back online. As a side note: is there any phone support in Australia or Movi Techs that you can call on in the event of an idiot like me not knowing what to do..??
G'day Simon: Sounds like you dug yourself out of that hole! There's a list of FF dealers here (at the bottom of the page): http://freeflysystems.com/dealers Hope this helps. Andy Forensic Software & sUAV / Drone Analyst : Photographer : Videographer : Pilot (Portland, Oregon, USA): Trees=2, Ground=1, Props=11. The Ground Is The Limit™ ---------- Forensic Drone Analyst : Forensic sUAV Analyst : Forensic Unmanned Aircraft Analyst : Forensic Drone Expert
Furkan: I'm afraid I do not -- and, worse yet, I'm not in my office to experiment. Your best bet is to open up a ticket by sending an email to Freefly Support (support@freeflysystems.com). Apologies! Andy Forensic Software & sUAV / Drone Analyst : Photographer : Videographer : Pilot (Portland, Oregon, USA): Trees=2, Ground=1, Props=11. The Ground Is The Limit™ ---------- Forensic Drone Analyst : Forensic sUAV Analyst : Forensic Unmanned Aircraft Analyst : Forensic Drone Expert