Separate names with a comma.
My opinion is that there is very little gain by going to 8S on this motor and more on the negative side like potential ESC problems. I would...
Yann, Are you trying to run the 490kv motor on 8s for additional power over say 6s or are you trying to gain efficiency by going to higher...
Thanks for the suggestion Gary.
My policy through AerialPak is getting close to renewal time. I was wondering if any of you have found worthwhile policies within the last year....
Gryphon dodeca looks pretty cool. How are the retracts? I don't know if CC has made any recent changes to their firmware, but the last time I...
Geoffrey, You may want to chat with the Kopterworx guys since they have more experience with the Dodeca arrangement and WKM. I have built a...
Ozkan, Sorry to hear about your motor failure as well, but thank you for sharing this. It does look like the same failure point. As for the...
Just an update on the status of the Gryphon. Patrick at KDE provided us with quick support to help us get airborne again. We ended up replacing...
Gary - thank you for the info on the CC speed controllers. I was able to find where you can set the data log to automatically reset. This will...
I've started digging into the electronics on the Gryphon to see if the CC Phoenix Edge Lite 75's had data on them. Both of the ESCs on the arm...
Regarding the data on props being strong enough to transmit forces to the shaft. All I have is my thirty years of flying model aircraft of all...
I visited Bryan last night to assist him with a small project and I picked up his Gryphon to assess the damage and to get it repaired. It is my...
Dave, Thanks for the feedback. That may not get us where we want, but that is still a fair gain.
At 33lbs., non-attitude mode I was hovering around 72%. I will probably give the custom mix a try not so much for a solution to the marginal...
Stock mixer. Have you found that you like the MK style better? I suspect it may help the slight yaw when bumping the throttle.
I recently finished a Gryphon Dynamics 1000mm X8 build and we have the KDE 4014 motors and Xoar 17x5" props mounted to it. DJI A2 and Castle...
Just wondering what others are doing and the experiences you are having. The MOVI appears to only recognize 9 output channels from Spektrum or...
Can someone tell me if the MOVI is compatible with the Futaba R7008SB receiver? We are looking at purchasing the 14SG for it's telemetry...
Trying to configure for this Graupner MX-20 / Spektrum DX6 dual setup. Deep into programming the Graupner radio to take over for single pilot...